1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

[Mysticism] Confused by Faster Casting CAPs

Discussion in 'UO Spellcaster' started by popps, Apr 6, 2011.

Moderators: Lady_Rachel, Tazar
  1. popps Stratics Legend

    On a character, I have both 120 Mysticism and 120 Spellweaving.

    Now, it seems that the faster casting CAPs are different. On Mysticism it is 2 and on Spellweaving it is 4.

    Now, when one has both skills on the same character which CAP applies ?

    Thanks.
  2. Podolak UO Moderator

    Hi Popps,

    It always applies the lowest cap to all skills. So lets say you had Chivalry and 70 or above Magery, your chivalry spells would be capped at FC2 along with the Magery ones.
  3. popps Stratics Legend

    I see, thank you for the reply.

    Now I understand why Word of death takes forever to cast. This must be because the CAP seen is the 2 of Mysticism and not that of 4 for Spellweaving......
    Each spellcasting skill should be treated differently though and go with its specific CAP even if on the same template.

    By the way, I checked on Protection - UOGuide, the Ultima Online encyclopedia about Protection and at some point it says :


    Is that still valid or can one now counter the negative effect of Protection as in regards to Faster Casting like putting on more Faster Casting points to take into account the penalty of 2 that applies to using Protection ?
  4. Cetric Crazed Zealot

    All spell casting caps are treated differently with the except of when you mix chiv with magery/mystic.



    so if you have 4fc 6fcr and 120 mystic and 120 spellweaving....


    you will cast at 2/6 with mystic spells and 4/6 with spellweaving spells.




    With the chiv exception, if you have 70 or more magery, your chiv FC cap drops to 2/6 casting, at 69.9 magery, the chiv cap is still 4/6. This part was done because people using 4/6 chiv heals and cures on full mages.


    Hope that helps.


    And on the protection post - You cannot counter the protection casting cap of 0 FC, even if you had 8 FC on, in pro you will be at 0 when speaking of magery.
  5. AzSel Lore Keeper

    Protection: If I understood that correctly tho, if you have FC4 and have protection on, your chivalry spells will still have FC2...right?
  6. elspeth Seasoned Veteran

    Would love to have official word about these caps. And if the above is true.

    So, if I do magery, mystic and spellweaving and have 4/6 on my jewelry then I should cast magery and mystic at fc2 and sw at fc4 and with protection on I'll cast magery and mystic at fc0 but sw at fc2?
  7. Obsidian UO Moderator

    No, my understanding is that Protection locks the cap for all casting, including Chiv and SW (which have a FC4 cap normally) at 0.
  8. Kylie Kinslayer UO Atlantic News Reporter

    One thing I have never been able to understand is how some people are able to cast a HECK of alot faster than I can. Have seen them cast gheal and fs at the same speed I cast gheal. I use 2/6, have a great connection (usually ping around 25-31) a great gaming pc, yet they cast like they have a 0 fcr time.
  9. Zero Day Journeyman

    Speed/Turbo casting has been in UO since the beginning, and technically you can cast one spell immediately after another even if you have 0 FCR.

    The way casting recovery in UO works, is that it is the time from when you begin casting a spell, until it is ready to be released.

    This is why if you watch old school mages fight, many times you will see them cast a spell, and wait a second or two to release it. The recovery time takes place after casting, not after release.


    If you cast spells immediately and back to back this is the sequence
    Cast->Release->Recover->Cast->Release


    To Speed Cast
    Cast->Recover->Release->Cast->Release
    No Delay between release of the spell and casting of the second spell, making
    interruption much more difficult

    This doesnt work with the new targeting system in the EC since it releases spells immediately once they are finished casting.

    This also doesnt work if you use last target queueing in UO assist, unless you wait to target the first spell.
  10. DJAd Slightly Crazed

    Yes, this is what I though happened also.

Share This Page