1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Greetings Guest!!

    In order to combat SPAM on the forums, all users are required to have a minimum of 2 posts before they can submit links in any post or thread.

    Dismiss Notice

Goza mats and arcane circles.

Discussion in 'UO Homes and Castles' started by Calibretto, Aug 5, 2008.

  1. Calibretto

    Calibretto Guest

    I tried to make my floor black with Goza mats. And then put my arcane circle out on top of it. Looks good at first but when I walk back into the room it's buried. Is there anyway to keep the arcane circle above the goza mats?
     
  2. Ashyn

    Ashyn Guest

    Yes. You need to place two layers of gazas, raising the top gaza by two (in the area you want the circle to be in. With this raised square of gazas, place the arcane circle on top and break the uppoer layer of gazas. The circle will stay above your lower "floor" gazas.

    Hope that helps.
     
  3. Sarsmi

    Sarsmi Grand Poobah
    Stratics Veteran

    Joined:
    Apr 25, 2001
    Messages:
    5,789
    Likes Received:
    6
    Alternately you can place the nine goza mats and raise each of them up by 1, place your arcane circle and then lower each of the goza mats by 1.
     
  4. Calibretto

    Calibretto Guest

    Both ways worked. Thanks for the help. ^^
     
  5. Starla

    Starla Guest

    Is there any similar ways to place polar bear deed on top of goza mats too? I tried for a while and is unsuccessful.
     
  6. feath

    feath Guest

    i was just going to say 'yes' right off the bat, as i had raised my polar bear rug before... but now wondering if thats how i did it.
    the bear has to be 1 click above the floor stuff, or it'll flip. sometimes only bits of it flip (and there are a LOT of parts to a bear rug!)... at 1 click, you can still walk over it.
    let me double check and get back.
    edit
    yup, works fine with gozas.
    3x3 squares of goza.
    raise them all 3 times.
    place bear rug.
    RAISE one large piece of bear rug (i used the butt end)
    LOWER the rest of the bear to the floor.
    Raise the floor bits up 2 clicks each, until all pieces line up, except the one piece you raised higher.
    this is just to make sure you have the bear at correct hight, not to get flipped with floor detail, but low enough to walk on. axe the goza's as you go. once the bear is broken, they aren't really needed, so long as you don't accedently connect your bear rug up again.
    once you're sure of your bear rug placement, lower the highest piece to match up with the rest of the rug.
    he's now whole again, and can be axed and redeeded if needed.
     
  7. Starla

    Starla Guest

    ^^ Thank You for your advice. Got it to place nicely finally.